The Future Of Heating & Cooling NV
Furnace Repair

Furnace repair Las Vegas NV done right the first time

When your heat quits on a 40-degree desert night, furnace repair Las Vegas NV homeowners can count on matters. We diagnose gas and electric furnaces across Clark County, from failed igniters to cracked heat exchangers, and we carry the parts to fix most systems on the first visit. If you need heater repair in Las Vegas, call (702) 666-4242 and we'll get your house warm again.

Service overview

What furnace repair Las Vegas NV really involves

Furnace repair Las Vegas NV is the diagnostic and mechanical work that restores heat to a home's forced-air system, and it usually starts with a no-heat call. Our technicians test the thermostat signal, check the igniter and flame sensor, verify gas pressure at the valve, and inspect the blower motor and capacitor. We use a digital multimeter and clamp meter to trace electrical faults, a combustion analyzer to check burner performance, and a thermal imaging camera to spot hot spots on the heat exchanger before they become a carbon monoxide problem. Las Vegas furnaces sit idle through 100-degree summers, then get slammed the first cold week of December. That on-off cycle is brutal on igniters, flame sensors, and blower motors, which is why we see so many furnace not igniting repair Las Vegas Nevada calls in late fall. If your system is blowing cold air or short-cycling, don't wait for it to fail completely. We offer affordable furnace repair in Las Vegas NV with upfront pricing before any work begins.

! Problems we solve

Furnace won't ignite or keeps clicking without lighting

You get cold air from the vents and the house drops fast overnight. Repeated ignition attempts can also wear out the control board, turning a $200 fix into a $600 one.

Furnace runs but the house never gets warm

The system runs constantly, driving up your gas bill while the temperature stays low. Often it's a clogged filter, a failing blower motor, or leaky ductwork losing heat in the attic.

Furnace banging, rumbling, or making loud noises

Banging on startup often means delayed ignition, where gas builds up before it lights. That's a safety issue, not just a noise complaint, and it can crack the heat exchanger over time.

Scope of work

What's included in our furnace repair service

Every furnace repair call includes a full diagnostic, a written price before work starts, the repair itself, and a post-repair safety check. Here's what that looks like in detail, so you know exactly what you're paying for.

  • 01

    Complete no-heat diagnostic

    We test the thermostat call, ignition sequence, gas pressure at the valve, flame sensor microamps, blower amp draw, and temperature rise. Takes 30 to 45 minutes and tells us exactly what failed instead of guessing at parts.

  • 02

    Written repair estimate

    Before we pick up a tool, you get a written price for the fix. If we find a second issue, it's quoted separately so you can decide what to do now and what can wait. No surprise charges on the invoice.

  • 03

    Repair with quality parts

    We use OEM or equivalent-grade igniters, flame sensors, gas valves, capacitors, and blower motors. Cheap aftermarket parts fail early and cost you a second service call. We'd rather do it once with the right component.

  • 04

    Post-repair safety and heat test

    After the repair, we run a full heat cycle, verify temperature rise at the supply and return, and check for gas leaks with a leak detector. On gas furnaces, we also run a combustion analyzer to confirm safe CO levels before we leave.

Why Las Vegas homeowners call us first

A dead furnace isn't a wait-and-see problem in the desert. Nights drop into the 30s, and a house without heat gets uncomfortable fast. Here's what you get when you book with us.

Book a repair

Tools and methods we use on every repair

Digital multimeter and clamp meter

Used to trace electrical faults through the thermostat circuit, test igniter resistance, and measure blower motor amp draw. These two tools find most no-heat electrical problems in under 20 minutes.

Combustion analyzer

Measures CO levels, oxygen, and flue temperature on gas furnaces after a repair. We run this on every gas job to confirm the burner is burning clean and safe before we leave your home.

Thermal imaging camera

Scans the heat exchanger for hot spots and cracks that a visual inspection can miss. Catching a cracked exchanger early prevents carbon monoxide from entering your living space.

Manifold gauge set and leak detector

Checks gas pressure at the valve on gas furnaces and verifies refrigerant charge on heat pump systems. The leak detector confirms no gas is escaping at any fitting after a repair.

Local execution

Las Vegas furnaces live a strange life. They sit unused through five months of 100-degree heat, then get hammered when the first cold front rolls through in late November or early December. That idle-then-stress pattern is why we see so many igniter and flame sensor failures in the first two weeks of cold weather. Desert dust is the other big factor. Fine grit gets past cheap filters, coats the flame sensor, and causes the furnace to shut down mid-cycle. We recommend MERV 8 to MERV 13 filters changed every 60 to 90 days during heating season. If you're searching for 24 hour heater repair Las Vegas near me during a cold snap, call us early in the evening rather than waiting until midnight. Our dispatch fills up fast on the first cold nights. Homes in older parts of town often have original ductwork with leaks that rob heat before it reaches the bedrooms, so we pressure-test ducts on any call where the furnace runs but the house stays cold.

How furnace repair runs in Las Vegas

  • • Enterprise
  • • Spring Valley
  • • Summerlin South
  • • Henderson

Recent work

No-heat call in Spring Valley [ A homeowner in Spring Valley called at 8 p.m. on a 38-degree night. The furnace was clicking but not lighting, and the house had dropped to 58 degrees. The system was a 12-year-old Goodman with a failed igniter and a flame sensor coated in dust. ]
Short-cycling fix in Henderson [ We replaced the filter, tested the limit switch, and confirmed proper airflow with an anemometer reading at each register. Temperature rise came back to spec and the furnace ran full 15-minute cycles. Runtime dropped by a third. ]
Detailed view of torch welding metal surface, featuring blue flame.
Always available
Always available

Available 24/7 when your heat goes out

When emergencies happen, we answer

Furnace failures don't wait for business hours, and neither do we. Our phone line stays open 24 hours a day, seven days a week, including holidays. Call (702) 666-4242 at 2 a.m. and you'll reach a live dispatcher who can give you a real ETA, not a four-hour window. On the first cold nights of the season, we run extra trucks and stagger dispatch so no one waits more than a couple of hours for a no-heat call. Every service vehicle carries the parts that cause 80 percent of winter breakdowns: igniters, flame sensors, capacitors, blower motors, and universal control boards. That means most emergency furnace repair Las Vegas calls get fixed on the first visit. If we can't fix it the same night, we'll tell you straight and get you on the schedule for the earliest slot the next morning.

24/7
Live dispatch coverage

How our furnace repair process works

1

Call and schedule

You call (702) 666-4242 or book online. We ask a few quick questions about your system, the symptoms, and your address so we can send the right tech with the right parts. Most calls get a same-day window, and emergency furnace repair Las Vegas requests get priority routing.

2

Full diagnostic

The tech arrives, confirms the complaint, and runs a complete diagnostic: thermostat call, ignition sequence, gas pressure, flame sensor microamps, blower amp draw, and heat exchanger inspection. Takes 30 to 45 minutes. You get a plain-English explanation of what failed and why.

3

Written estimate

Before any repair starts, you get a written price for the fix. If we find a second issue, we quote it separately so you can decide. No work happens until you approve the number. This is where most homeowners tell us they appreciate the honesty.

What furnace repair costs in Las Vegas

Furnace repair pricing in Las Vegas depends on the part that failed and how hard it is to reach. A simple igniter or flame sensor swap runs $180 to $320. A blower motor or control board replacement runs $450 to $850. Diagnostic fees are $79 to $129 and get credited toward the repair when you approve the work. After-hours and emergency calls add a modest surcharge. We quote every job in writing before we start, so you never get a surprise on the invoice. For 2026, these ranges reflect what we're actually charging on real jobs across the valley.

01

Part cost and availability

A universal igniter costs far less than a brand-specific control board for a Carrier or Trane unit. If the part is on our truck, you pay the standard price. If we have to order it, the cost goes up slightly and the repair takes an extra day or two.

02

Access and labor time

A furnace in a closet is a 45-minute job. The same repair on an attic unit in a 140-degree space takes twice as long. We quote labor based on realistic time, not a flat book rate that punishes you for having a hard-to-reach system.

03

Time of day and season

Standard business hours are the cheapest time to book. Nights, weekends, and holidays carry an after-hours surcharge. The first cold week of December is our busiest stretch, so booking a fall tune-up in October usually saves money and avoids the rush.

Licensed, certified, and reviewed

"Called at 7 a.m. with no heat and had a tech at the house by 10. He found a cracked igniter, had the part on the truck, and we had heat by noon. Fair price, clean work, and he explained everything without trying to sell me a new furnace." — Google

Furnace repair questions answered

How much does furnace repair cost in Las Vegas NV?

Most furnace repairs in Las Vegas run $180 to $650, with the average around $320. A simple igniter or flame sensor swap sits at the low end. A blower motor or control board replacement pushes toward the top. Diagnostic fees typically run $79 to $129 and get credited toward the repair if you approve the work. Emergency and after-hours calls add a modest surcharge.

Why is my furnace not turning on in Las Vegas?

The three most common causes we find are a failed igniter, a dirty or dead flame sensor, and a tripped safety switch from a clogged filter. In Las Vegas, dust and fine desert grit accelerate filter loading, which causes the furnace to overheat and shut down on the high-limit switch. If your thermostat is calling for heat and nothing happens, that's usually an ignition or control board issue.

Who does emergency heater repair near me in Las Vegas?

We do. Our team runs 24/7 emergency coverage across Las Vegas and Clark County, including nights, weekends, and holidays. Call (702) 666-4242 and you'll get a live dispatcher, a real ETA, and a tech who carries the common parts to get your heat back the same night. Most emergency calls get resolved in a single visit.

Is it worth repairing an old furnace in Las Vegas NV?

If your furnace is under 15 years old and the repair is under $800, fixing it almost always beats replacing it. Past 18 to 20 years, or if you've had two or more repairs in the last three seasons, replacement starts to make more financial sense. We'll give you both numbers and let you decide without pressure.

!

Get furnace repair Las Vegas NV homeowners recommend

No heat is not something to sleep on. Call (702) 666-4242 and we'll get a tech to your door, usually the same day. Upfront pricing, licensed work, and a warranty on every repair. If your furnace is down, we're ready to bring the heat back.

Call Now: (702) 666-4242